When Start Frequency is Less Than 7
If the start frequency is less than 7
install the 2-7
air line as follows:
TURN
HOLD
Move the Port 1 nut to its standard position. Carefully
insert the air line outer conductor and center pin into the
male connector using the installation tool.
Hold the air line outer conductor and tighten the Port 1
nut finger tight. Use the torque wrench to achieve the
final torque.
Connect the 2-7 Line
l
Press the tool lightly to engage the center conductor.
Engage the Center Conductor
l
Squeeze the tool to close the slot, then pull the tool away
from the connector, leaving the center conductor.
Remove the Tool
l
Examine the outer and center conductors to see that they
are in place and concentric. If the center conductor is not
centered, use the tip of the installation tool to align it.
GOOD
BAD
Check the Concentricity
l
Move the air line nut back to expose the center
conductor. Carefully engage the Port 2 female contact
with the Port 1 male contact. Be patient making this
connection because it is easy to move the center
conductor off center.
Move the Nut Back
22
