Thermal locations for computer models equipped with discrete graphics are shown in the following
illustration:
●
Thermal paste is used on the processor (1) and the heat sink section (2) that services it.
●
Thermal paste is used on the graphics board processor (3) and the heat sink section (4) that services it
Reverse this procedure to install the fan/heat sink assembly.
Base enclosure
Description
Spare part number
Base enclosure
For 15.6-in. models
738692-001
For 14-in. models
738681-001
Before removing the base enclosure, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
Battery on page 56
), and then remove the following components:
a.
Service cover (see
Service cover on page 57
)
b.
Hard drive (see
Hard drive on page 58
)
c.
Optical drive (see
Optical drive on page 69
)
82
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Summary of Contents for 645 G1
Page 4: ...iv Safety warning notice ...
Page 10: ...x ...
Page 37: ...Computer major components Computer major components 27 ...
