HP 64147A, User Manual

Page: 51 / 105

Displaying Trace with
No Symbol
The trace listing shown above has symbol information because of the
"set symbols on" setting before in this chapter. To see the trace listing
with no symbol information, enter the following command.
set symbols off <RETURN>
Trace List Depth=512 Offset=0
Label: Address Data Opcode or Status w/ Source Lines time count
Base: hex hex mnemonic relative
##########spmt_demo.c - line 201 thru 204 ############################
semantic_check()
{
int i;
after 00F462 3B0B PHD 120 nS
+001 00F464 E938 E938H opcode fetch 240 nS
+002 00F463 0694 TSA 240 nS
+003 000690 0694 0694H data write 120 nS
+004 00F464 0694 SEC 120 nS
+005 00F465 0002 SBC A,#0002H 280 nS
+006 00F466 0002 0002H opcode fetch 120 nS
+007 00F468 3A1B 3A1BH opcode fetch 360 nS
+008 00F468 3A1B TAS 120 nS
+009 00F469 645B INC A 120 nS
STATUS: M37750/51--Running user program Emulation trace complete______...R....
set symbols off
run trace step display modify break end ---ETC--
As you can see, the analysis trace display shows the trace list without
symbol information.
Displaying Trace with
Compress Mode
If you want to see more executed instructions on a display, the 7750/51
emulator Softkey Interface provides compress mode for analysis
display. To see trace display with compress mode, enter the following
command:
display trace compress on <RETURN>
Getting Started 2-29