HP 64147A, User Manual

Page: 56 / 105

Installing the
Target System
Probe
Caution
POSSIBLE DAMAGE TO THE EMULATOR PROBE. The
emulation probe contains devices that are susceptible to damage by
static discharge. Therefore, precautionary measures should be taken
before handling the microprocessor connector attached to the end of the
probe cable to avoid damaging the internal components of the probe by
static electricity.
Caution
POSSIBLE DAMAGE TO THE EMULATOR. Make sure target
system power is OFF before installing the emulator probe into the
target system. Do not install the emulator probe into the processor
socket with power applied to the target system.
Caution
DAMAGE TO THE EMULATOR WILL RESULT IF THE
PROBE IS NOT INSTALLED CORRECTLY. Make sure pin 1 of
probe connector is aligned with pin 1 of the socket. When installing the
emulation probe, be sure that the probe is installed into the processor
socket so that pin 1 of the connector aligns with pin 1 of the socket.
Note
When you use the emulator in-circuit, turn ON the target system first,
then turn ON the emulator. Likewise, turn OFF your target system first,
then turn OFF the emulator.
3-2 In-Circuit Emulation