HP 64147A, User Manual

Page: 31 / 105

Pod Command Help
To access the emulator’s firmware resident Terminal Interface help
information, you can use the following commands.
display pod_command <RETURN>
pod_command ’help cf’ <RETURN>
Pod Commands
Time Command
iram - set internal ram address space
irom - set internal rom address space
ipmr - set processor mode register address
mode - select processor mode
mon - selection of a foreground or background monitor
clk - select internal or external emulation clock
int - enable INT input from target system
rdy - enable/disable insertion one clock RDY while memory access
rush - select high speed access mode
wdog - enable/disable watch dog timer
rsp - set value of SP ( stack pointer ) after emulation reset
rrt - restrict to real time runs
dmdt - specify DT to mnemonic display
tdma - enable trace dma cycles
trfsh - enable trace refresh cycles
thold - enable trace hold cycles
STATUS: M37750/51--Running in monitor_________________________________...R....
pod_command ’help cf’
run trace step display modify break end ---ETC--
The command enclosed in string delimiters (", ’, or ^) is any Terminal
Interface command, and the output of that command is seen in the
pod_command display. The Terminal Interface help (or ?) command
may be used to provide information on any Terminal Interface
command or any of the emulator configuration options (as the example
command above shows).
Note
If you want to use the Terminal Interface command by entering from
keyboard directly, you can do it after entering the following command.
pod_command keyboard
Getting Started 2-9