HP 64147A, User Manual

Page: 28 / 105

HPB3078-11001 A.06.10 06Mar95
M37750/51/34 SOFTKEY USER INTERFACE
A Hewlett-Packard Software Product
Copyright Hewlett-Packard Co. 1994
All Rights Reserved. Reproduction, adaptation, or translation without prior
written permission is prohibited, except as allowed under copyright laws.
RESTRICTED RIGHTS LEGEND
Use , duplication , or disclosure by the Government is subject to
restrictions as set forth in subparagraph (c) (1) (II) of the Rights
in Technical Data and Computer Software clause at DFARS 52.227-7013.
HEWLETT-PACKARD Company , 3000 Hanover St. , Palo Alto, CA 94304-1181
STATUS: Starting new session__________________________________________...R....
run trace step display modify break end ---ETC--
Figure 2-3. Softkey Interface Display
Configure the
Emulator for
Examples
To do operations described in this chapter (loading absolute program
into emulation memory, displaying memory contents, etc), you need to
configure the emulator as below. For detailed description of each
configuration option (question), refer to the "Configuring the
Emulator" chapter.
To get into the configuration session of the emulator, enter the
following command.
modify configuration <RETURN>
Answer to the series of questions as below.
Micro-processor clock source? internal <RETURN>
Enter monitor after configuration? yes <RETURN>
Restrict to real-time runs? no <RETURN>
Reconfigure emulator? yes <RETURN>
Processor type ? <chip_name> <RETURN>
Select the <chip_name> you are going to emulate. Appropriate
<chip_name> is listed in Processor Support List for HP MELPS
emulators. If your processor is not listed in this guide, refer to chapter 4
of this manual for information on configuring the emulator.
2-6 Getting Started