Multimedia Traffic Control with IP Multicast (IGMP)
CLI: Configuring and Displaying IGMP
Viewing the Current IGMP Configuration.
This command lists the IGMP
configuration for all VLANs configured on the switch or for a specific VLAN.
Syntax:
show ip igmp config
IGMP configuration for all VLANs on the switch.
show ip igmp < vid > config
IGMP configuration for a specific VLAN on the switch,
including per-port data.
show ip igmp group < ip-address >
Lists the ports on which the specified multicast group
IP address is registered.
(For IGMP operating status, see the appendix on monitoring and analyzing
switch operation in the
Management and Configuration Guide
.)
For example, suppose you have the following VLAN and IGMP configurations
on the switch:
VLAN ID VLAN Name
IGMP
Enabled
Forward with
High Priority
Querier
1
DEFAULT_VLAN Yes
No
No
22
VLAN-2
Yes
Yes
Yes
33
VLAN-3
No
No
No
You could use the CLI to display this data as follows:
Figure 4-1. Example Listing of IGMP Configuration for All VLANs in the Switch
The following version of the
show ip igmp
command includes the VLAN ID
(
vid
) designation, and combines the above data with the IGMP per-port
configuration:
4-7
Summary of Contents for 2610
