HP 2610, Advanced Traffic Management Manual

Page: 283 / 364

IP Routing Features
Configuring IRDP
[ minadvertinterval < seconds > ]
This parameter specifies the minimum amount of time the
routing switch can wait between sending Router
Advertisements.
Default: three-fourths (0.75) the value of the
maxadvertinterval parameter.
If you change the
maxadvertinterval
parameter, the software
automatically adjusts the minadvertinterval parameter to be
three-fourths the new value of the
maxadvertinterval
parameter. If you want to override the automatically
configured value, you can specify an interval from 1 to the
current value of the
maxadvertinterval
parameter.
[preference < number >]
This parameter specifies the IRDP preference level of this
routing switch. If a host receives Router Advertisements from
multiple routers, the host selects the router interface that sent
the message with the highest preference as the host's default
gateway. The valid range is -4294967296 to 4294967295.
Default: 0 .
Displaying IRDP Information
To display IRDP information, enter the following command from any CLI level:
ProCurve# show ip irdp
Status and Counters - ICMP Router Discovery Protocol
Global Status : Disabled
VLAN Name Status Advertising Min int Max int Holdtime Preference
Address (sec) (sec) (sec)
-------------- -------- ------------ ------- ------- -------- -----------
DEFAULT_VLAN Enabled multicast 450 600 1800 0
VLAN20 Enabled multicast 450 600 1800 0
VLAN30 Enabled multicast 450 600 1800 0
Figure 7-9. Example of Displaying IRDP Information
7-25