EN
Master Language is English
Hot Runner System Installation Guide
SVC-17-0001_EN-Rev13
RESTRICTED: Property of Synventive.
- 606 -
All rights reserved. Errors and omissions excepted
For limited third party distribution based on need and intended use.
© 2021 Synventive Molding Solutions
H O T R U N N E R T E C H N O L O G Y
Hot Runner System Installation Guide
Service and Maintenance / Disassembly the Nozzle 16S-06 / 22S-0S Series
Mounting the Nozzle Front Heater
1) Assemble the nozzle body (1) on the nozzle head (11), as described in the
above page 602.
2) Assemble the rear heater (3) on the nozzle body (1), as described in the
above page 604.
3) Lead the cable of the front heater (5) through the cover tube (7).
4) Hold the cover tube (7) to the front heater (5).
5) Bend the cable at the front heater (5) corresponding to the opening at the
nozzle head (11) about 90 degrees.
Doc008815_RIS.png
6) Slide the cover tube (7) together with the front
heater (5) over the nozzle body (1).
NOTICE
The wire from the front heater (5) must be
at the opening from the rear heater (3).
Doc008833_RIS.png