EN
Master Language is English
Hot Runner System Installation Guide
SVC-17-0001_EN-Rev13
RESTRICTED: Property of Synventive.
- 603 -
All rights reserved. Errors and omissions excepted
For limited third party distribution based on need and intended use.
© 2021 Synventive Molding Solutions
H O T R U N N E R T E C H N O L O G Y
Hot Runner System Installation Guide
Service and Maintenance / Disassembly the Nozzle 16S-06 / 22S-0S Series
4) Screw in the nozzle body (1) hand-tight into the nozzle head thread until
seated.
5) Unscrew the nozzle body (1) from the nozzle head (11).
Doc008826_RIS.png
6) Check the matching between the nozzle head (11) bottom surfaces
(SF2) and the nozzle body (1) surface (SF1).
NOTICE
The nozzle head must bear on all surfaces uniformly and
flatly, in particular on the nozzle head contact face.
In case of any uncertainty, clean the surfaces with a cleaning
cloth. If the next ink test is still unsatisfactory, please - contact
Synventive Customer Service or Technical Support.
7) With a positive ink test, clean the surfaces and proceed to the next step.
Doc008827_RIS.png
8) Lubricate the thread (not the face) of the nozzle body (1) with high-
temperature assembly paste (antiseize compound).
NOTICE
This is an important measure to prevent thread corrosion due
to aggressive gases, which could be released during plastics
processing.
Doc003827.png