Hoshizaki IM-240AME, Service Manual

Page: 43 / 100

39 39
E1CG4880210 E1CG4880210
Fig. 31 Fig. 31
Icemaker Icemaker Cooling Cooling
Tower
Tower
Flow Control Valve Flow Control Valve
Strainer Strainer Pump Pump
P P
Potable Water Potable Water
Inlet G3/4
Inlet G3/4
Inlet Hose Inlet Hose
Drain Outlet R3/4 Drain Outlet R3/4
(on left side of
(on left side of
Storage Bin)
Storage Bin)
Outlet Hose Outlet Hose
Cooling Water Cooling Water
Inlet Rc1/2
Inlet Rc1/2
Cooling Water Cooling Water
Outlet Rc1/2
Outlet Rc1/2
1/2-3/4 Nipple 1/2-3/4 Nipple
Condenser Cooling Circuit Condenser Cooling Circuit
Icemaker Icemaker
Bin Bin
Fig. 30 Fig. 30
3) Attach grey flexible outlet hose (accessory) to the R3/4 fitting on the left side of the Storage 3) Attach grey flexible outlet hose (accessory) to the R3/4 fitting on the left side of the Storage
Bin as indicated (Fig. 28), confirming fitment of rubber washer before finally hand tightening Bin as indicated (Fig. 28), confirming fitment of rubber washer before finally hand tightening
the joint. This pipe can be cut to length as necessary to suit position of main drain.
the joint. This pipe can be cut to length as necessary to suit position of main drain.
4) By means of a suitable spanner or wrench, tighten the 1/2-3/4 nipples (accessory) into the 4) By means of a suitable spanner or wrench, tighten the 1/2-3/4 nipples (accessory) into the
Rc1/2 fittings on the left side of the icemaker as indicated. P.T.F.E. tape and/or a suitable Rc1/2 fittings on the left side of the icemaker as indicated. P.T.F.E. tape and/or a suitable
sealing compound should be used to obtain a leak free joint.
sealing compound should be used to obtain a leak free joint.
Note: Jointing compounds should be approved and suitable for potable water use. Note: Jointing compounds should be approved and suitable for potable water use.
5) Connect the Condenser cooling circuit to the free end of 1/2-3/4 nipples as indicated (Fig. 5) Connect the Condenser cooling circuit to the free end of 1/2-3/4 nipples as indicated (Fig.
30) using a suitable rigid type pipe. 30) using a suitable rigid type pipe.