Hoshizaki IM-240AME, Service Manual

Page: 39 / 100

35 35
E1CG4880210 E1CG4880210
Fig. 23 Fig. 23
Junction Box Cover Junction Box Cover
Screw Screw
Fig. 25 Fig. 25
Gasket Gasket
Nut Nut
Bushing Bushing
Cap Cap
Condenser Unit Condenser Unit
Fan Motor Fan Motor
Wiring Cord
Wiring Cord
Junction Box Junction Box
(Fan Motor Leads inside)
(Fan Motor Leads inside)
Cord Grip Cord Grip
Securing
Securing
Hole
Hole
Closed End Closed End
Connector
Connector
Inside Inside Outside Outside
Wiring Cord Wiring Cord
Gasket Gasket
Fig. 24 Fig. 24
Condenser Unit Condenser Unit
Fan Motor Leads
Fan Motor Leads
Nut Nut
Cap Cap
Bushing Bushing
[d] ELECTRICAL CONNECTIONS [d] ELECTRICAL CONNECTIONS
WARNING WARNING
THIS APPLIANCE MUST BE EARTHED THIS APPLIANCE MUST BE EARTHED
This remote Condenser Unit requires an earth that meets the national and local This remote Condenser Unit requires an earth that meets the national and local
electrical code requirements. To prevent possible severe electrical shock to
electrical code requirements. To prevent possible severe electrical shock to
individuals or extensive damage to equipment, install a proper earth wire to the
individuals or extensive damage to equipment, install a proper earth wire to the
icemaker and ensure continuity to the Condenser.
icemaker and ensure continuity to the Condenser.
* This Condenser Unit must be connected to the * This Condenser Unit must be connected to the
Fan Motor Junction Box on the icemaker. Fan Motor Junction Box on the icemaker.
* Usually an electrical permit and services of a * Usually an electrical permit and services of a
licensed electrician are required. licensed electrician are required.
1) Remove the two screws and the Junction Box 1) Remove the two screws and the Junction Box
Cover of the Condenser Unit. See Fig. 23. Cover of the Condenser Unit. See Fig. 23.
2) Connect the Fan Motor leads and earth wire in 2) Connect the Fan Motor leads and earth wire in
the Junction Box to the installed three-wire cord the Junction Box to the installed three-wire cord
using proper wire connectors. See Fig. 21.
using proper wire connectors. See Fig. 21.
3) Secure the three-wire cord in position with the 3) Secure the three-wire cord in position with the
Cord Grip provided. Cord Grip provided.
Note: Note: The space in the Junction Box is limited. Make the connections outside the Junction The space in the Junction Box is limited. Make the connections outside the Junction
Box before securing the Cord Grip on the Condenser Unit inside by using the Nut
Box before securing the Cord Grip on the Condenser Unit inside by using the Nut
and Bushing provided.
and Bushing provided.
4) Replace the Junction Box Cover in its correct position and secure it with the two screws 4) Replace the Junction Box Cover in its correct position and secure it with the two screws
provided. provided.