Horizon Reverse Osmosis Seafari Versatile Series, Owner'S Manual

Page: 73 / 209

Seafari Versatile 450 - 1800
Page 6-1
6
press the “Booster Pump” switch and then the
“Start” switch.
If the System automatically shuts off after
several seconds of operation, look at the
Touch Pad to determine whether a fault has
occurred. If so, correct fault and repeat Step 11.
For fault explanation, see following page.
12. Bleed all air from the Commercial Pre-filter
[14] and Oil/Water Separator [17] by opening
the air bleed valve located at the top of the
each housing [15 & 18] and close when water
displaces all of the air.
13. Slowly adjust the Back Pressure Regulator
Valve [33] by turning clockwise to increase the
pressure up to the proper setting (850 psi for
35,000 ppm seawater).
For BRACKISH WATER operation, adjust the
pressure from 100 PSI to 850 so the product
water output, is within system specifications.
Hourly Production:
Model
Gal Lit
Horizon Seafari 400-1
18 70
Horizon Seafari 700-1
26 110
Horizon Seafari 900 / 900-2
38 140
Horizon Seafari 1400-2
58 220
Horizon Seafari 1800-2
75 285
CAUTION : Do not exceed product water
flow specifications.
14. If any abnormality develops, stop the System
and correct the problem.
15. Use the Product Water Flow Meter [42] to
measure the product flow. The salinity of the
Product Water diminishes gradually, until
the product water reaches the factory setting
at which time the product water passes into
the Post Filtration components, and onto the
Ship’s Storage Tank [46].
16. Check for unusual noises or other occurrences.
6.1.1 SOFT START OPERATION
The Horizon Seafari system may have a Soft Start
installed. This Soft Start reduces the current (amps)
required at startup for single-phase systems.
This is accomplished by reducing the startup torque
of the motor. There are a few things one should
know when operating a system equipped with a
6 SYSTEM START UP & SHUTDOWN
6.1 START UP PROCEDURE
1. Check the level of the oil in the High Pressure
Pump crankcase. Ensure that the oil level is
higher than the center of the sight glass.
2. Open the Inlet Sea Cock Valve [2] fully.
3. Position the Clean/Rinse Inlet Valve [4], if
installed, to the normal operating position.
4. Position the Clean/Rinse Outlet Valve [35], if
installed, to the normal operating position.
5. Open any auxiliary Valve within the incoming
Feed Line.
6. Open any auxiliary Valve in the Outgoing
Brine Discharge Line.
7. Open any auxiliary Valve in the Outgoing
Product Water Line.
8. Set the Multi Media Filter Valves, if installed,
for the Normal Operating Position.
9. Fully Open the Back Pressure Regulator
Valve [33].
10. Switch the Electrical Power Source to the
Salinity Controller [56] “ON”.
11. To start the system press the “Start” switch, or
Main Power
Enclosure
Low Pressure Gauge
Brine/Flow Meters
R.O. Membranes
High Pressure Gauge
Back Pressure
Regulator Valve