Horizon Reverse Osmosis Seafari Versatile Series, Owner'S Manual

Page: 41 / 209

Page 4-1
4
Seafari Versatile 450 - 1800
4 SYSTEM INSTALLATION
4.1 ON SITE STORAGE AND PREPARATION
FOR INSTALLATION
4.1.1 STORAGE PRIOR TO UNCRATING
1. Adhere to crate markings:
•
DO NOT store in direct sunlight;
• DO NOT store above 120 degrees F / 50° C
•
DO NOT freeze; STORE ONLY on base
with ARROWS UP
• DO NOT store longer than 3 months with-
out additional storage chemical rinsing.
2. Refer to Section 8 of this manual for further
cautions of the R.O. Membrane Element.
4.1.2 AVOID CHEMICAL ATTACK TO THE SYSTEM
CAUTION
: Do not expose the Horizon
Seafari System to:
•
hydrogen peroxide
•
chloramine
•
chloramine-T
•
N-chloroisocyanurates
•
chlorine dioxide
• hypochlorite,
•
chlorine
• iodine
•
bromine
• bromide
•
phenolic disinfectants
or any other specific chemical not
approved in writing by HRO Systems.
Use of unauthorized or misuse of
authorized chemicals voids system
warranty.
NOTE : Numbers in [ brackets ] refer to the
I.D. numbers illustrated on page 3-2 or 4-5.
4.1.3 COMPONENTS SUPPLIED BY OWNER:
1. Inlet Thru Hull Fitting with Inlet Sea Cock
Valve
[1&2]
• ¼ - turn ball valve min. ¾" size, with a
¾" MNPT connection for the supplied
HRO fitting.
This inlet must be installed below water level
and must never be able to draw air.
The system intake must be located toward the
bottom when a stand up pipe is used.
2.
Brine Thru Hull Fitting
[36]
• A minimum ½" size with a
½" MNPT connection.
• Must be located above water level.
• If a Multi-Media Filter is installed, an
additional waste fitting, minimum ½"
size with ½" MNPT for connection to the
supplied HRO fittings.
3.
Potable Water Storage Tank
[46]
• The installation fitting must be at least a
3/8" NPT with 3/8" FNPT for connection
of the HRO fittings.
• The fitting must terminate above the
maximum water level.
• No valves should be installed in this line.
4. Properly Sized Power Cable :
Operating Voltage 115 VAC, Single Phase,
Recommended Minimum Size Power Cable:
10 AWG
Operating Voltage 230 VAC, Single Phase,
Recommended Minimum Size Power Cable:
12 AWG
Operating Voltage 230 VAC, Three Phase,
Recommended Minimum Size Power Cable:
12 AWG
Operating Voltage 380-460 VAC, Three Phase,
Recommended Minimum Size Power Cable:
14 AWG
5. An electrical power source capable of
supplying the proper current at the proper
Voltage to the Horizon Seafari System.
4.1.4 TOOLS REQUIRED FOR INSTALLATION
Of course, not all installations are typical. For this
reason, it is recommended to have a full set of
mechanic’s electrician’s tools available. However,
no special system tools are required for installation.
Though not always necessary, a separate DS Meter,
available from HRO Systems, and a volt/ohm meter
(VOM) are beneficial and useful tools for system
installation and initial start-up.