Horizon Reverse Osmosis Seafari Versatile Series, Owner'S Manual

Page: 54 / 209

Seafari Versatile 450 - 1800
Page 4-14
4
Allow minimum 4" below the bottom of the
bowl for Pre-filter Element removal.
See also Item #14 (page E – 16) for close up of the Low Pressure
Pick Up Tee.
Connect the Booster Pump Outlet (or Plankton
Filter Outlet if used or Multi Media Filter
Outlet if used) to the Pre-filter Inlet.
If the Oil/Water Separator is not used then
connect the Standard Pre-filters Outlet to the
High Pressure Pump Inlet.
11. Commercial Pre-filter [14] replaces the
Standard Pre-filters.
It is not necessary to use both the Commercial
Pre-filter and Standard Pre-filters.
The Commercial Pre-filter, must be positioned
on a firm, flat surface and mounted in place
with the supplied hardware.
Allow 12 inches above the Commercial Pre-
filter assembly for filter element removal.
Connect the Commercial Pre-filter Inlet Port
to the Booster Pump Outlet (or Plankton Filter
Outlet if used or Multi Media Filter Outlet if
used).
12.
Oil/Water Separator
[17] follows the
Commercial Pre-filter.
The Oil/Water Separator Assembly is
plumbed for water flow in the opposite
direction as the Pre-filter.
Tee one end of Pressure Pick Up to
Outlet Gauge of Pre-filtration Unit
Tee opposite end of
Pressure Pick Up to System
Low Pressure Gauge
Standard Pre-filter
Outlet (To High
Pressure Pump Inlet)
In line Low Pressure
Pick Up Tee (See also #14)
Standard Pre-filter Inlet
(From Booster Pump)
Using the supplied ¾” hose, connect the
Oil/Water Separator Inlet to the Standard or
Commercial Pre-filter Outlet.
Connect the Oil/Water Separator Outlet to the
High Pressure Pump Inlet.
NOTE
(Refer to pg. 4-15.): The Oil/Water
Separator utilizes the same filter housing
as the Commercial Prefilter. However, the
Oil/Water Separator is plumbed opposite
of (backwards from) the Commercial
Prefilter. The standard filter housings
have raised arrows and lettering
molded indicating correct flow for the
Commercial Prefilter. These markings
are INCORRECT for the Oil/Water
Separator. The OIl/Water Separator’s
correct water flow enters the center core
of the filter element and migrates to the
outer surface of the filter element.
13.
Self-Contained / Modular System Mounting
Must be readily accessible for daily operation
and periodic maintenance.
Components within the system must be
readily access able for maintenance.
Ensure that all tubing and hoses are routed
without kinks or sharp bends.
Mount the System on a firm flat surface and
secure in place.
Modular System mounting:
The controls within the System must be
readily accessible for daily operation.
Ensure that all tubing and hose connections
have sufficient space to be routed without
kinks or sharp bends.
Keep the system within close proximity to the
Pre-filtration Components and High Pressure
Pump to ensure minimal line loss.