Horizon Reverse Osmosis Seafari Versatile Series, Owner'S Manual

Page: 104 / 209

Seafari Versatile 450 - 1800
Page 8-8
8
18. Refill the Rinse/Clean Tank [50] with non-
chlorinated product water.
19. Position the Rinse/Clean Outlet Valve [35]
to the Clean/Rinse Tank [50] for Rinse Re-
circulation.
20. Press the “Start” switch to re-circulate the
water from the Rinse/Clean Tank, through the
system, and back into the Rinse/Clean Tank.
Continue rinsing for 20 minutes.
21. After 20 minutes stop the system by pressing
the “Stop” switch.
22. In order to empty the Clean/Rinse Tank,
position the Rinse/Clean Outlet Valve [35] to
the Brine Discharge, normal operating position.
23. Press the “Start” switch to discharge the
rinse water out the Brine Discharge Thru
Hull Fitting [36].
24. Just prior to depleting the rinse water from the
tank, stop the system.
25. Refill the Rinse/Clean Tank [50] with non-
chlorinated product water.
26. Position the Rinse/Clean Outlet Valve [35]
to the Brine Discharge, normal operating
position.
27. Start the system to begin rinsing the System,
and discharging out the Brine Discharge Thru
Hull Fitting to waste.
28. Just prior to depleting the Final Rinse Water
from the tank stop the system.
The System is now ready for additional cleaning,
Storage, or use.
If further cleaning is necessary, repeat steps 10
through 28 for each additional cleaning.
If cleaning is completed and the System is to
be stored, go to the beginning of this section
and review the Storage Procedures and
Cautions.
If cleaning is complete and the System will be
operated again within a short period of time,
proceed to step 29 below.
29. Position the Clean/Rinse Inlet Valve [4]
towards the Sea Strainer, normal operating
position.