Horizon Reverse Osmosis Seafari Versatile Series, Owner'S Manual

Page: 57 / 209

Page 4-17
4
Seafari Versatile 450 - 1800
22.
Brine Thru Hull Fitting
[37] must have a
1/2" MNPT nipple fitting inside the hull for
connection of the Brine Discharge Tee [36]. It
must be above Sea Level.
23. Clean/Rinse Outlet Valve [35]
This optional valve is used with the Inlet
Clean/Rinse Valve #4 to assist in rinsing and
cleaning of the System.
Install the Outlet Clean/Rinse Valve between
the Brine Discharge and the Brine Discharge
Tee Connector [36]. Using the Supplied 1/2
inch O.D. Tubing.
Connect one side port of the Outlet Clean/
Rinse Valve to the Brine Discharge Tee
Connector [36].
Connect the other side port to a Clean/Rinse
Tank [50] Return or to a length of hose that can
later be placed into a temporary Clean/Rinse
Tank, Container or Bucket.
Connect the Center port to the Brine Discharge
Tee Connector [36].
24. Remote Control
Often, the Remote Control Touch Pad is
mounted in a recessed hole. After measuring
the Remote Control Panel, routing out the
indent and cutting the Cable hole, place the
Touch Pad into the indent and check for
sizing. Clean up the indent as required for a
good fit. If the indent was made in wood or
other porous surface then it is best to seal the
surface of the indent so that the Touch Pad
properly adheres to the indent surface. Once
the indent hole has been sized and sealed
ensure that the indent is “squeaky clean”
and free of dust so that the double stick tape
attached to the Touch Pad properly adheres to
the indent surface. Remove the green paper
from the back of the Touch Pad to expose the
double stick tape attached to the back of the
Touch Pad. Position the Touch Pad directly
over the Indent and press firmly into place for
a permanent bond.
25.
Electrical Connections
(also refer to Section 11
for electrical diagrams)
Electrically connect, if
not already connected, the following to the
Horizon Seafari Controller:
•
Optional U.V. Sterilizer
• Optional Fresh Water Flush Valve
•
Optional Remote Unit
• Main Incoming Power
•
Booster Pump Motor
• High Pressure Pump (Modular)
•
High Pressure Pump Thermal
(Modular) Low Pressure Switch
• Salinity Probe (Modular)
•
Soft Motor Starter
Rancho Dom
inguez, C
A, USA
Tel: (310) 631-
6300
• Fax: (310) 631-
6395
© 20
08 H
orizo
n Rev
erse O
smosis
. Mad
e in th
e USA 3"
76.2 mm
2.5"
63.5mm
.75"
19 mm
0.1"
2.5 mm
Remote Touch Pad Cut Out Dimensions for Mounting
From System Brine
Discharge (½" Tube)
To Brine Discharge
Fitting [36] (½" Tube)
To Clean/Rinse Tank
Return (½" Tube)