42
Section 15: Rudder, Elevator and Throttle Pushrod Installation
Step 9
Locate the smaller 1.5mm, 19
1
⁄
2
" pushrod and thread
a clevis onto the threaded end. Insert the rod into the
throttle pushrod tube previously installed.
Step 10
Install the easy connector to the throttle servo arm by
inserting the bottom post through the second hole from
the end in the throttle arm. Install the snap washer on
the easy connector stem, securing it to the arm.
Step 11
Connect the clevis end of the pushrod to the throttle arm.
Step 12
Turn on your radio system and center your transmitter’s
throttle stick and trim and center your throttle servo
arm. Put the throttle arm of your engine to the
1/2 open/closed position.
Step 13
With your radio system on, the throttle controls centered,
and throttle arm in the 1/2 open/closed position, secure
the throttle pushrod wire to the easy connector by
tightening the screw in the top of the connector to the
pushrod wire. Trim off the excess wire.
