User Manual
XYR301E Wireless Ethernet
34-XY-25-41
Page 65
Devices on LAN B & LAN C that needs to send messages back to LAN A will need to have their Gateway addresses
directed to the XYR301-E on their respected networks. I.e. a LAN B device needs to send data back to LAN A. The
Gateway address will need to be configured as 169.254.109.40 as this is the IP address of the wired side of the LAN B
XYR301-E. Any message coming in with a 192.168.0.X IP address will be directed across the wireless interface to
LAN A.
The Routing Rules configuration page can be accessed by selecting the “Routing” link on any of the configuration web
pages. Up to 30 routing rules may be added to each XYR301-E. The table below summarizes the configurable
parameters of a routing rule.
Name
A name to describe the routing rule (Max 32 characters).
Destination
The destination network (or host) IP address (to specify a network address set the host
address to 0. i.e. for an IP address 192.168.0.0 with Netmask 255.255.255.0 would specify a
destination network, while 192.168.0.16 specifies a destination host).
Subnet Mask
The subnet mask for the destination network.
Gateway
The IP address of the next-hop router for the specified destination.
Enabled
Check this box to enable the rule. You can Uncheck the box to disable a routing rule without
needing to re-enter the information at a later time.
Note: Entering dedicated Ethernet Routes can also be added to the wired Ethernet LAN in place of
generating / adding routing rules into the modems.
Summary of Contents for XYR301E
Page 2: ...Page ii April 2012 ...
Page 18: ......
