Honeywell Thor CV41, User Manual, Page: 62 / 118

54 CV41 Vehicle Mount Computer (Windows Embedded Standard) User Guide
3. Select the profile you want to configure.
4. For 8021x , choose LEAP .
5. For
Association
, choose
Open
,
WPA
,
WPA2
, or
Network EAP
. Encryption
automatically defaults to TKIP if you choose WPA , AES if you choose WPA2 , and
WEP
if you choose Open or Network EAP.
6. For Prompt for Credentials , choose Enter credentials now .
7. Enter a
User Name
and
User Password
.
8. Save your settings.
Configure Static WEP Security With Wireless Security
Use the following procedure to configure static WEP security with Wireless. Honeywell
recommends that you use WPA2-PSK instead of WEP if possible.
1. Make sure the communications and radio parameters on your computer are config-
ured.
2. Make sure Wireless is selected as your security choice.
3. Start Intermec Settings.
4. Choose Communications > 802.11 Radio > Wireless Security .
5. Select the profile you want to configure.
6. For 8021x choose None .
7. For
Association
, choose
Open
.
8. For Encryption , choose WEP .
9. Define a value for the keys you want to use. You can define up to four keys (
Key 1
through Key 4 ).
Enter an ASCII key or a hex key that is either 5 bytes or 13 bytes long depending on
the capability of the radio. Set a 5-byte value for 64-bit WEP or a 13-byte value for
128-bit WEP. Hex keys must be preceded by 0x and contain 5 or 13 hex pairs.
10. For
Transmit key
, choose the key you want to use for transmitting data.
11. Save your settings.
Use Open (No Security) Associations with Wireless Security
Use the following procedure to configure your computer for open security using Wire-
less.
1. Start Intermec Settings.
2. Choose
Communications
>
802.11 Radio
>
Wireless Security
.
3. Select the active profile you are using.
4. For
Association
, choose
Open
.
5. For Encryption , choose None .
6. Tap
OK
. Your settings are saved.