HTR62 Installation and Operating Guide
Rev 1.01
25
Document 900.0341
12/05
Inserting a Tape in the VCR
To insert a tape in the VCR:
1.
Unlock the access panel on the front of the VCR enclosure.
2.
If the vehicle ignition is off, press POWER on the front panel of the VCR. The VCR
must be powered to accept the tape.
3.
Insert the video tape into the slot until the VCR pulls the tape inside. Do not force the
tape to avoid damaging the VCR.
Starting Recording
Turn the vehicle ignition on. The VCR automatically starts recording after approximately 10
seconds, subject to Record Delay and Timer settings.
You can also start recording by pressing the REC button on the remote control.
Note
Unless the VCR is in temporary power mode, the vehicle engine must be
running to ensure that the battery voltage is high enough to start the HTR62
system.
Stopping Recording
Turn the ignition off.
If the Delayed-off time (see
Lines 5 and 6
, page
20
) has been programmed to 00
minutes, the VCR switches off.
If the Delayed-off time has been programmed for 01 to 20 minutes, the VCR remains
on for the specified time after the vehicle ignition is switched off.
You can also stop recording by pressing the STOP button on the remote control or the
STOP/EJECT button on the front panel of the VCR.
Note
The VCR begins recording again after one minute of no button activity if the
ignition trigger is still active.
Summary of Contents for HTR62
