Rev 1.01
13
Document 900.0341
12/05
3
System Setup
The HTR62 comes with a handheld wireless remote control. This chapter describes how
to use the remote control to program the VCR. After you have done the initial system
setup,
Chapter 4
shows you how to use the remote control for basic operating functions.
Programming Controls
Before you use the remote control, install the CR2025 battery (supplied with the remote
control) inside the battery compartment. Then, simply point the remote control at the front
panel of the VCR.
Note
Install the battery into the remote c side up.
Several of the buttons have dual functions (see
Figure 3-1
). That is, during Play mode
each button functions as labeled, but during Program mode several buttons function
differently.
Table 3-1
lists the remote control buttons and describes their functions in Play
and Program modes.
Summary of Contents for HTR62
