HTR62 Installation and Operating Guide
Rev 1.01
11
Document 900.0341
12/05
b.
Enter programming mode (refer to the manual that came with your existing
system).
c.
Note the settings on the Program screen(s) (for example, bus title, status
indicators, bus speed calibration). You will need these settings to program into
the new VCR after installation.
3.
Power down the VCR.
4.
Remove the 3A fuse from the power cable.
5.
Remove the existing unit by loosening the velcro retaining strap and pulling it towards
you until it is free of the enclosure.
6.
Disconnect the power connector, video and audio connectors, and DB25 wiring
harness.
7.
Remove the VCR. Set aside.
8.
Replace the existing VCR with the new VCR.
9.
Plug the camera into the Cam 1 input for a one camera system. If you are using a
second camera, plug it into the Cam 2 input (see
Figure 2-2
)
10. Program the new VCR.
HTRGPS Module Installation
Note
The HTRGPS Module is an optional component. Contact your sales
representative or Honeywell Sales for more information about this product.
The HTRGPS Module easily installs at the rear of the enclosure base. Refer to the HTRGPS
Module Installation Application Note for complete installation instructions. See
Chapter 3
for
information on programming the VCR to accept and display GPS data.
Summary of Contents for HTR62
