Honeywell HREP216, User Manual

Page: 90 / 200

90 | Performance Series HREP2 DVR User Guide
www.honeywell.com/security
• S.M.A.R.T STATUS : Read the S.M.A.R.T information of the disk and check to display
if the current disk is in normal operation.
• NORMAL : The disk is in a normal state.
• CHECK : The disk has an error so that you need to check the disk or the
connection cables of the disk.
If you leave the problem unresolved, no recording may be enabled. So it is
recommended that you replace the disk immediately.
• ERROR : The disk fails or is unable to use due to an error of the disk or the cable.
The disk should be replaced immediately. Contact the retailer or the customer
service to replace the disk.
3. When finished, press the EXIT button on the remote control or click CLOSE in the lower
part of the screen to return to the previous menu.
Disk Operations
You can set to delete the recording automatically and set the overwrite options, and you can
also format the HDD recording data.
1. From SYSTEM SETUP

STORAGE , select DISK OPERATIONS (see Figure 4-43 ).
Figure 4-43 Disk Operations Screen
2. Use the

,

,

,

, and ENTER buttons on the remote control or use the mouse to set
the operation conditions of the disk.
• DISK WRITE MODE : Specify the option for writing to the disk.
• If it is set to OVERWRITE , the existing data will be overwritten by new recording
data if the recording data size exceeds the free space of the HDD.
• If the option is set to ONCE and the HDD is full, the DVR will stop recording and
output the beep or alarm that is pre-defined at EVENT .
• RECORDING TIME LIMIT : The recording data will be deleted after a specific time of
reservation. If it is set to OFF , this function will be disabled.
For example: Record Time Limit set to 1 day . Even if there is sufficient free space in
the HDD, it records / keeps videos of the most recent 1 day only.
• DISK FORMAT : Format the hard disk.