Honeywell HEN04111, User Manual

Page: 71 / 248

NVR Configurations | 71
800-18160 - A - 06/2014
DHCP Used to automatically search for the IP address. When the
DHCP function is enabled, you can not modify the IP address,
Subnet mask, or Gateway. If you have not enabled DHCP, the
IP address, Subnet mask, and Gateway are all
0 by default.
To view the current the IP information, you must turn off
DHCP.
You can not modify the IP address, Subnet mask, or Gateway
if you are using PPPoE.
TCP Port Default is 37777 . This value is configurable.
UDP Port Default is 37778 . This value is configurable.
HTTP Port Default is 80 .
RTSP Port Default is 554 .
Note If you change and any of the above port settings, you must reboot your NVR to
activate those saved settings. Please ensure that the these port settings do not
conflict.
Max Connection The NVR can support up to 20 users. 0 means that this NVR
can not connect to any PC or other device.
MTU Configure the MTU value for the network adapter. Select from
1280 to 7200 bytes. The default is 1500 bytes.
Note MTU modification can affect the current network
service. Click
OK to confirm a reboot, or click Cancel
to cancel the modifications.
Note Before configuring the MTU for the NVR, check the
gateway’s MTU. The NVR’s MTU should be the same
or lower than the MTU’s gateway. This helps to reduce
the number of packets and increases network
transmission efficiency.
MTU Values (reference
only) 1500 : The Ethernet information packet maximum value. This
is also the default value, especially where there is no PPPoE
or VPN. This is also the default setup for some routers,
switches, or the network adapter.
1492 : The recommended value for PPPoE.
1468 : The recommended value for DHCP.
Please ensure that the MTU port does not conflict with other
ports.
Preferred DNS Server Enter the preferred DNS server IP address.
Alternate DNS Server Enter an alternate DNS server IP address.
Transfer Mode Select a priority, either Fluency or Video Quality .
LAN Download If you enable this function, the NVR can process the
downloaded data first. Select a download speed, either
1.5x
or 2.0x the normal speed.
Table 3-12 Network Configurations
Parameter Function