Honeywell HD54IP, User Manual

Page: 37 / 84

Performance Series Rugged Day/Night H.264 IP Dome Camera User Guide
Document 800-09311V3 Rev A 37
07/2013
5. Automatically discover or manually refresh the list of devices on the network.
Use the manual refresh if a new device was added after you logged onto the system.
• You do not need to do anything to discover devices. When you log on to the IP
Utility, the devices on the network — including the devices on other subnets —
are automatically discovered and listed in the Discovery pane. After the initial
discovery, the network automatically continues to discover devices that are newly
added to the network.
• To manually refresh the device list, click the Refresh ( ) button, located near
the top of the Discovery pane.
6. Enable or disable the HTTP Server check box for additional security. Only an
Administrator can disable (uncheck the box), resulting in the user being unable to
access the web client, although video recording is unaffected.
Figure 3-2 Honeywell IP Utility User Interface
The About menu displays the
software version installed.
The Status bar displays how many
devices are on the network, which
one you are connected to, and
which user is logged on.
The Discovery pane lists
the IP devices found on the
network and groups them
by device type.
On the User tab, Administrators
can change the web-client user
passwords.
IP Network Setting assigns
network settings automatically
or manually.
Connect button
Disconnect button Limited/No connectivity
button
Refresh button
Upgrade Firmware
downloaded from the
Honeywell web site.
Use the Product Filter drop-down
menu to select a specific device,
such as all HD4 series cameras.
Click Apply to save
manually configured
network settings.
Use Launch Browser
to open the HD4
series IP web client for
each device.
Use Batch Firmware Upgrade
to select a group of devices and
upgrade the firmware for all.
Enable or disable HTTP
Server.