COMPONENT MAINTENANCE MANUAL
00001059
TASK 21-22-91-100-808-A01
8.
Procedure 4: Cleaning of Parts with Alcohol-Based Cleaning Agent
A.
Reason for the Job
WARNING:
– DO NOT BREATHE THE FUMES. THE SOLVENTS ARE DANGEROUS.
– USE EYE PROTECTION. DO NOT LET THE SOLVENTS TOUCH YOUR SKIN.
– CLEAN THE PARTS IN A ROOM WHERE AIRFLOW IS SUFFICIENT.
– DO NOT CLEAN NEAR AN OPEN FLAME.
CAUTION:
– CAREFULLY OBEY THE CLEANING PROCEDURES, OR REPLACE THEM WITH
A PROCEDURE WHICH IS SPECIFIED BY THE MANUFACTURER IF YOU USE
EQUIVALENT PRODUCTS.
– AFTER YOU COMPLETE THE PROCEDURE, YOU MUST PUT PROTECTIVE
CAPS OR APPLICABLE PACKAGING MATERIAL ON THE PARTS.
(1)
This procedure is specially applicable to:
– hardware electrical component parts,
– electronic component parts,
– printed circuits.
B.
Job Set-up Information
(1)
Consumable Materials
CODE
REFERENCE
DESIGNATION
M09A
DENATURED METHANOL (OM23214)
DENATURED METHANOL
(a)
Use a cleaning material which agrees with Specification MIL-A-6090.
(b)
Example: - Cleaning material (M09A).
C.
Job Set-up
Not applicable. Use the cleaning material as it is.
D.
Procedure
WARNING:
– IN WORKSHOPS, KEEP THE ALCOHOL-BASED CLEANING AGENTS IN SMALL
QUANTITIES (250 CM³ (15.25 CU.IN)).
– CLEAN THE PARTS IN A ROOM WHERE AIRFLOW IS SUFFICIENT.
– DO NOT CLEAN NEAR AN OPEN FLAME OR AN INCANDESCENT MATERIAL.
SUBTASK 21-22-91-110-003-A01
(1)
Cleaning
(a)
Clean parts with a soft brush.
(b)
Dry with compressed air at ambient temperature.
E.
Close-up
Not applicable
21-22-91
Page 4011
Dec 15/06
The document reference is online, please check the correspondence between the online documentation and the printed version.