Honda Aircraft Company
HA-420
OPERATING PROCEDURES
POM
AND TECHNIQUES
HJ1-29000-005-001
October 30, 2016
3-19
BEFORE TAKEOFF
Accomplish the Before Takeoff checklist in accordance with the AFM.
Verify that flaps are in the desired position for takeoff (UP or TO/APPR)
and the posted speeds and entered required runway distance are
appropriate for the selected flap position. Confirm the pitch trim setting
in the green band. Roll and yaw trim shall be centered (green) for
takeoff.
CAS Messages
During normal operations there will be no CAS alerts present. Nominal
system operations such as use of engine anti-ice may result in white
status CAS messages. The pilot should review each CAS message.
Navigation
Select the appropriate navigation source for departure. If necessary, set
the course deviation indicator (CDI) to the course desired for takeoff and
departure. Verify the CDI course and distance based on departure
instructions. Display SID chart if appropriate and increase map range to
show initial departure route.
Flight Guidance
Select the TOGA switch. It is recommended that TO mode is used in the
lateral axis, and HDG or NAV is selected after takeoff as appropriate, to
ensure proper FD commands in case of an engine failure during takeoff.
Set the altitude and heading targets according to ATC clearance.
TOLD Data
Reference the AFM to confirm performance data. If using performance
data from preflight planning, confirm that conditions have not changed to
invalidate charted performance.
FOR TRAINING PURPOSES ONLY
