CYLINDER HEAD/VALVES
Check the contact between the valve and valve
seat w i t h Prussian Blue.
If the contact area on the valve face is too
high, the seat must be lowered, w i t h a 37.5°
grinding stone.
T O P C U T
CONTACT
TOO HIGH
M A T E R I A L REMOVED
WITH 37.5° STONE
O L D SEAT
W I D T H
If the contact area on the valve face is too
low, the seat must be raised, w i t h a 63.5°
grinding stone.
Refinish the seat to 1.0 mm (0.0394 in.)
w i d t h , w i t h a 45° finishing stone.
CONTACT
TOO LOW
O L D SEAT
W I D T H
M A T E R I A L
REMOVED
W I T H 63.5°
STONE
B O T T O M C U T
After grinding the seat, apply lapping com-
pound to valve face and lap the valve lightly.
CAUTION
Do not allow the lapping compound to
enter the valve guide.
After lapping, wash any residual com-
pound off the cylinder head and valve.
Date of Issue: December, 1977
© H O N D A MOTOR CO., L T D .
6-15
Summary of Contents for CM 185T 1981
