Honda Acura NSX 1991, Service Manual

Page: 855 / 1420

8. Thoroughly mix the adhesive and hardener
together on a glass or metal plate with a putty
knife.
NOTE: Clean the plate with a sponge and alcohol
before mixing.
9. Follow the instructions that came with the
adhesive.
10. Before filling a cartridge, cut off the end of the noz-
zle at the angle shown.
Cut off
end as shown.
10 mm
(0.4 in.)
mm (0.28 in.)
11. Pack adhesive into the cartridge without air
pockets to ensure continuous delivery. Put the car-
tridge in a caulking gun and run a bead of adhesive
around the edge of the glass as shown.
NOTE: Apply the adhesive within 30 minutes after
applying the glass primer.
4 mm (0.15 in)
I
13 mm
: ADHESIVE I
(0.5 in)
8 mm (0.3
Make a slightly
thicker bead at
.
each corner
12. Use suction cups to hold the glass over the open-
ing, align it with the marks made in step 4 and set it
down on the adhesive. Lightly push on the glass
until its edges are fully seated on the adhesive all
the way around.
NOTE: Do not close or open the doors until the
adhesive is dry.
MARK8
13. After the adhesive is dry, spray water over the
glass and check for leaks. Mark leaking areas and,
let the glass dry, then seal with sealant.
NOTE: Let the car stand for at least 4 hours after
glass installation. If the car has to be used within
the first 4 hours, it must be driven slowly.
14. Connect the rear sub-harness and ground
cable/antenna lead, then install the grommets.
15. Reinstall all remaining removed parts.