Honda Acura NSX 1991, Service Manual

Page: 550 / 1420

Bearing Outer Race
Replacement (Clutch housing side)
Bearing Preload
NOTE:
l The outer race and bearing should be replaced as a
set.
l
Inspect and adjust the bearing preload whenever the
bearing is replaced.
1 . Remove the outer race, 90 mm washer and oil
guide ring.
2.
DRIVER
0 7 7 4 6 - 0 0 1 0 0 0 0
ATTACHMENT,
0 7 7 4 6 - 0 0 1 0 5 0 0
the oil guide ring and 90 mm washer, then
the outer race into the clutch housing.
ATTACHMENT,
Adjustment
NOTE: If any of the items listed below are replaced, the
bearing preload must be adjusted.
HOUSING
CLUTCH HOUSING
DIFFERENTIAL
TAPER ROLLER BEARING and OUTER RACE
75 mm THRUST SHIM
90 mm WASHER
OIL GUIDE RING
1 .
Remove the bearing outer race and 75 mm thrust
shim from the transmission housing by prying up
on the bearing outer race or by heating the housing
to about
CAUTION: Do not reuse the thrust shim if the
outer race was pried out.
NOTE:
l
Let the transmission cool to the room tempera-
ture if the outer race was removed by heating
the case before adjusting the bearing preload.
Do not heat the transmission housing in excess
of
Replace the bearing with a new one whenever
the outer race is replaced.
Repeat on the clutch side.
There is no shim on the clutch side.
BEARING OUTER
R A C E
\
76
mm
THRUST SHIM
Replace.
TRANSMISSION
HOUSING