Homeright Power-Flo, Instruction Manual, Page: 7 / 40

7
Priming
Spraying
This is only a quick reference. Read the entire instruction manual prior to using the product.
Submerge suction tube in paint. Turn Power Switch ON, and trigger gun into
waste pail. When paint comes out of drain tube, turn Prime/Spray valve to
SPRAY. When paint comes out of gun, release trigger. Pump will build up
pressure and motor will stop.
Put trigger safety lever in SAFETY
ON position.
1
1
PRI M
E
S
P
R
AY
2
Install tip and guard on gun
and hand tighten. If tip clogs,
reverse spray tip to quickly clear
obstructions without dissasembly.
2
Correct
Incorrect
4
FAST START QUICK REFERENCE GUIDE
Transfer drain tube to paint pail.
3
Setup
Remove spray tip and guard from gun.
1
Connect hose to gun and sprayer.
2
Turn Power Switch OFF. Plug sprayer
into grounded outlet.
3
bar/MPa/psi
Turn pressure control knob
clockwise to increase pressure
and counter-clockwise to decrease
pressure at the gun.
bar/MPa/psi
3
bar/MPa/psi
Point gun 12” from surface and begin
moving gun before triggering. Set
pressure to spray without “tails.” If
tails persist at highest pressure, switch
to smaller tip or thin material.
Flushing
Turn pressure control knob counter-
clockwise to minimum pressure.
Turn Spray/Prime valve to PRIME.
bar/MPa/psi
1
Place drain tube into waste pail.
Submerge suction tube in water
(water-based materials) or thinner/
cleaner solution (oil-based materials.)
2 4
Turn Power Switch ON. Turn Pressure
Control Knob clockwise until pump
starts.
3
bar/MPa/psi
Allow fluid to flow out of prime tube
into waste pail for 30-60 seconds.
Turn power switch OFF.
P
R
IM
E SP
R
A
Y
Spray
Clean
Meijer.com