36
Deutsch (Übersetzung der originalen Anleitungen)
36
English (Original instructions)
Engine starts but will not
accelerate properly.
Check for lubricating function.
Run at half throttle 30 to 45 seconds. Stop saw
and check for lubricant dripping from guide bar. If
lubricant is present, the chain may be dull or bar
may be damaged. If no lubricant is on the guide
bar, contact a Homelite service dealer.
Bar and chain running hot
and smoking.
Chain brake engaged.
Release chain brake, refer to “Operation –
operating chain brake” earlier in this manual.
Chain tension too tight.
Tension chain per instructions in “Maintenance –
adjusting the chain tension” earlier in this manual.
Check guide bar and chain
assembly.
Refer to “Maintenance – assembling the bar and
chain” earlier in this manual.
Check guide bar and chain for
damage.
Inspect guide bar and chain for damage.
NOTE:
The carburettor adjustment needle(s) are equipped with plastic cap(s) which prevent anticlockwise rotation from
the original factory adjustment. If your product exhibits specific performance problem(s) where the troubleshooting section
recommends an anticlockwise needle adjustment and you have made no adjustments since the original purchase, take
the product to a factory authorised service dealer for repair. In most cases, the needed adjustment is a simple task for
the factory trained service representative.
