3
As shown in Fig. 3, we use a roller
for gluing R9 and R10. This allows
the glue to be applied in an
evenly thin layer. Press the parts
together for several hours.
Glue the balsa strips R8 flush to the fuselage sides at the bottom.
Now glue the wing supports made of plywood R6 flush on the top of the fuselage sides. Take
care to remove any glue that may escape in the slots for holding the wing bolts.
In the canopy area, glue the plywood strip R7 flush with the fuselage, again paying attention
to left and right.
Frames R1 to R5 have a small notch on the top. The servo board R3 is marked on the leading
edge, as are the 4mm plywood parts. Now glue the two M5 nuts from the accessories into the
4mm plywood parts of the wing bolts R11 and R12.
Two servo boards are included in the kit, one servo board with cutouts and one without. The
servo board with cutouts is intended for the HEPF H47 (rudder) and the KST X06 (elevator).
The second servo board without cutouts is intended for servos similar in construction, these
can be fitted individually.
Part R25 behind the
motor bulkhead
