16
The parts for the edge arch (1-5)
are found in the 8mm balsa.
These can be used after personal
taste be glued together, we use
an offset on the Trailing edge of
approx. 2mm.
Tip: here with one piece
Household foil the building
board protect the parts of the
Edge arc with the straight one
Place the underside and glue
together.
The glued together edge sheet is attached to the protruding carbon spar and adapted to the
shape of the wing. The edge curve is sanded first and then glued to the wing ear.
When building the second wing part, make sure that this part is mirror-inverted must be
built! (left and right wing ear, turn the base plate for this).
The surface parts B are just like
the surface parts C built up.
The only difference is that also
here a 7mm aluminum tube as
Glued in surface plug-in must
become. Also is be careful that
both the root rib as well as the
End rib inclined 5 degrees.
Important here: the aluminum
tube of the Area mating before
the glue in sand to produce a
rough surface.This is the only
way to ensure a safe Bonding.
In addition, the aluminum tube
with a small plywood circle from
the base plate locked.
The following picture is now also
the area mating and the small
reinforcement on the Leading
edge already glued in place
