HOLZMANN MASCHINEN Austria www.holzmann-maschinen.at
Strana 39
OSCILAČNÍ HRANOVÁ BRUSKA / OSCILLATING EDGE BELT SANDER KOS 3000C
14
OPERATION
Device to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, electrical controls, electric cables and screwed
connection for damage and if tightened properly. Replace any damaged parts before operating
the device.
14.1
Operation instructions
W A R N I N G
Perform all machine settings with the machine being
disconnected from the power supply!
A T T E N T I O N
Please observe the following operating instructions so that their
work can be performed safely and has the expected success.
N O T I C E
Check before starting work:
All cables and plugs
Table and safety fence on tight fit
The free and centered run of sanding belt and disc
The sanding:
Always use the proper, located in perfect condition abrasives.
(Change wear of abrasives immediately!) With abrasive in good
condition you obtain a good grinding result.
Do not exert too much pressure to the sanding abrasive
The machine has no clamp opportunity, so it is important, as the
whole area hang up the work piece on the worktable and maintain a
firm grip!
Summary of Contents for KOS 3000C
Page 60: ......
