Holiday imperial 2001, Owner'S Manual, Page: 141 / 301

1. Two exposed electrical studs are mounted
externally at the forward end of the awning at the
motor assembly. An alternate 12 Volt DC positive
and negative supply may be supplied to these con-
nections. If awning fails to move, reverse the polari-
ty of the alternate supply leads.
2. On the motor assembly, mounted externally at
the forward end of the awning, is an opening. Insert
a 9/64” Allen hex wrench. Using an electric drill,
wind the awning to the retract position.
CAUTION: When using an alternate
method to operate the awning, use
extreme care to keep appendages,
hair or loose clothing away from
exposed rotating hardware.
Water weights 8.33 pound per gallon. The awning was not made to with-
stand the 500 to 700 pounds that could accumulate. It is best not to subject the
awning and the motorhome to the needless strain.
To extend the sunvisor press and hold the lower portion of the control
switch until the desired location is obtained. Once the desired point is obtained
the sunvisor will remain in that position until changed. Retracting the sunvisor
is the same as extending, except the upper portion of the switch is used.
Cleaning the sunvisor should be done using a soft clean brush to remove dust.
Equipment
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
I M P E R I A L 5 • 1 4 1
Electric Studs
Insert Allen wrench here.
12 Volt Motor.
SUNVISOR
SUN
VISOR
UP
DOWN