10. Built-in devices
119
To operate
Start / stand-by screen
A few seconds after the control panel has been connected to the
power supply, a start screen will appear.
If nothing is entered for several minutes, a stand-by screen will
automatically be displayed.
Functions
The functions in the menu lines
l
and
m
of the control panel can
be selected in any sequence. The operating parameters are shown in
the status line
k
or in the display
n
and
o
. Functions may vary,
depending on the equipped fittings and model.
When the time is set (see “Setting the time”) the display
alternates between the time and the room temperature
that has been set. If no time has been set, the set room
temperature will be displayed permanently.
To switch on/off
To switch on
• Press the adjusting knob / pushbutton
q
.
Previously set values / operating parameters will be
reactivated when the control panel is switched back on.
To switch off
• Press the control knob / pushbutton
q
for longer than 4 seconds.
iNet-ready
: After 2 seconds, “APP” appears on the display;
after a further 2 seconds, “OFF” appears on the display.
Due to an internal lag feed in the heating or air-condi-
tioning system, it may take a few minutes for the Truma
CP plus control panel to switch off (during this time you
will see “OFF” on the display).
Selecting the setting mode
Press the control knob / pushbutton
The display shows the setting mode. The first icon flashes.