❏
9. Mount the radio tray in the fuselage with the #2 x 3/8"
[10mm] screws.
Mount the Servos
❏
1. Make two 18" [460mm] pushrod tubes from the 3/16"
[4.8mm] gray pushrod tubes supplied with this kit. (It doesn’t
matter which tubes you cut them from as there will be plenty of
tubing leftover anyway.) Thoroughly roughen both ends of the
tubes with coarse sandpaper so glue will adhere. Do not use
any glue until instructed to do so.
❏
2. Enlarge the holes in the fuselage so the pushrod tubes
will go through. The holes should be long enough to
accommodate the tubes at a small angle as shown in the
sketch above.
❏
3. Guide the tubes through the holes up through the fuselage
into the radio compartment.
❏
4. Fit the tubes through the 1/8" [3mm] plywood pushrod
brace, then position the brace behind the former as shown.
Refer to this photo while installing the servos and hooking
up the pushrods.
❏
5. The same as was done for the aileron servo, make one
two-arm servo arm and two one-arm servo arms by cutting off
the unused arms. Save two of the cut off arms for use later
when hooking up the antenna.
❏
6. Install a brass screw-lock pushrod connector in the third
hole out into the two-arm servo arm (or, like the aileron servo
13
