11
1.
Collect the following items
(1) Rudder
(2) Elevators
(12) CA hinges
(1) Fuselage
Hinging Elevator and Rudder
2.
Mount the three servos as shown above using
the hardware that comes with the radio. All
three output arm go forward.
2.
Trial fit the elevator in place with the CA
hinges just as we did with the ailerons. Use a
pin in the center of the hinge to make sure it
stays centered. Make sure the counter-bal-
ances on the tip do not interfere with the stab.
3.
When satisfied with the fit, hold the elevator
tight against the stab and move to its full
deflection in one direction. Glue hinges in
place with thin Ultra Set CA. Move the eleva-
tor to full deflection in the opposite direction
and glue from the other side.
4.
Repeat the process for the rudder. Make sure
the counter balance on top is free to move.
Rudder Cables
1.
Collect the following items
(1) Braided cable
(4) cable swages
(2) rigging couplers
(2) swivel pushrod fittings
(1) 6-32 x 3” threaded rod
(2) nylon ball nuts
(2) nylon cup washers
(2) nylon pushrod fittings
