5
2.
Center the servo arm in the opening in the
door and mark the location of the mounting
blocks.
Epoxy the 3/8” x 3/4” blocks to the door.
3.
Mount the servo to the blocks using the hard-
ware that comes with the radio.
4.
Make sure the servo is centered and attach the
servo arm.
5.
Attach a 24” servo lead extension to the servo
lead.
Pull the wire through the wing and exit the root
rib.
IMPO
RTANT!
To ensure that any connections locat-
ed inside the wing will not come loose, either when
the wires are pulled, or during flying,
always tape
them securely together with electrical tape.
6.
Mount the servo door to the wing using four #2
x 3/8” screws.
7.
Locate two of the 4-40 x 3-1/2” pushrods and
install a clevis and silicone keeper on each
end.
8.
Move the flap down and install the pushrod on
the flap horn.
mark
9.
Pull the pushrod up to the side of the door
opening and make a mark in line with the cle-
vis pin.
