(6) After the joiners have dried, apply epoxy where shown. The wing roots, the
wing joiners and inside the other wing joiner slot should be evenly covered with
epoxy.
(9) Drill two 8mm holes into the wing joiners for the dowel rods.
(7) Slide the two wing halves together slowly and wipe off any excess glue. Hold
the two wing halves firmly together with tape until the epoxy has cured.
(10) Epoxy the Iwo dowel rods into the holes. Make sure they are all the way in.
(8) Once dry, remove the tape. Position the front joiner as shown. The flat edge of
the joiner should line up with the top of the wing. next, remove and epoxy in
that same position Let cure.
(11) Position the wing center cover on the bottom of the wing. Apply Cyanoacrylate
glue under the edges and hold until it dries.
-5-
