WING ASSEMBLY
(A) Right Wing (Aileron Installed) . . . 1
(B) Left Wing (Aileron Installed) . . . . 1
(C) Main Wing Joiner . . . . . . . . . 2
(D) Rear Wing Joiner . . . . . . . . 1
(E) Front Wing Joiner . . . . . . . . . 1
(F) Wing Center Cover (Plastic) . . . . 1
(G) 8mm Dowel Rods . . . . . . . . . 2
(H) Wing Bolt Mounting Block . . . . . 1
(3) Remove the foam covering from the aileron servo mounting area. Test fit the
main wing joiner and the rear wing joiner in the right and left wing sections. The
dihedral angle of the joiners should make the wing tips slightly higher than the
center.
(I) Wing Mounting Brace . . . . . . . . 1
(J) 4x30mm Bolts . . . . . . . . .2
(K) 4mm Washer . . . . . . . . . . .2
(L) 0-Ring . . . . . . . . . . . . . .2
(M) Aileron Servo Tray . . . . . . . . . 1
(N) Aileron Servo Tray Mount . . . . . 1
(0) Main Servo Tray . . . . . . . . . . 1
(1) Check each wing half for smooth aileron operation. It is a good ideal to exercise
(move back and forth) the ailerons to insure easy deflection. Sand the end if any
rubbing is noticed.
(4) Make sure that there is no gap between the wing halves. If there is, sand the wing
joiner ends until there is a tight fit.
(2) Align and epoxy the two main wing joiners together. Hold tight until the glue sets.
You'll notice that there is dihedral angle cut into the joiners so make sure they are
perfectly lined up.
(5) Apply epoxy to one half of one side of both the main and rear wing joiners and
glue them to one wing half. Make sure the dihedral angle is correct and that they
are slid in all the way.
-4-
