9
A
A.. Insert the Black Nozzle into the Rubber “Stopper.”
B
B.. Cut the fuel line to 2-3/4" (70mm) and install it onto the black nozzle and to
the Metal fuel pickup (commonly referred to as the “clunk”).
C
C.. Insert the stopper into the tank and tighten the cap. You may need to
lubricate the stopper with skin oil (best found on the sides of your nose) to
help it install easier.
STEP 1: Assemble the Fuel Tank
Fuel Tank and Radio Tray Installation
Part
Part
T
T
wo
wo
C
C.. Carefully install the fuel
tank into the fuselage
while pulling the tubing
from the front.
A
A.. Insert the fuel tubing
into the holes located
on the firewall.
STEP 2: Install the Fuel Tank
Insert the two longest Pushrods into
the tubes from inside the fuselage.
The longer
of the two
pushrods
goes here.
If the pushrod guides are not pre-installed,
cut the pushrod guides approximately 1/2"
ahead of the bulkhead.
STEP 3: Insert the Pushrods
D
D.. Slide the fuel tank in place. Make sure the fuel line
is not pinched during installation. This will cut off
the fuel supply to the engine.
B
B.. Attach the tube that
goes through the left
hole to the black
nozzle. Attach the
tube that goes
through the right hole
to the top nozzle on
the tank. N
No
otte
e:: The
middle nozzle will
not be used.
Cut to 2-3/4” long.
Pushrod
Rubber Stopper
Cap
Black
Nozzle
Clunk
Actual Size
Fuel Line
N
No
otte
e:: “Left” and
“Right” are as
viewed from the rear
of the airplane.
