A
A.. Install the two remaining clevises with retainers
onto the short pushrod wires.
B
B.. Connect the rods using the nylon retainers.
C
C.. Adjust the clevises so the ailerons are centered
when the servo is centered.
STEP 8: Install the Aileron Pushrods
C
C.. Attach the switch to the
left side of the fuselage.
STEP 7: Attach the Switch
A
A.. Slide a silicone clevis retainer onto each
wire pushrod. Attach the clevises onto
the threads using the tool provided.
B
B.. Make sure the servos do not move.
C
C.. Screw the clevises on so that the control
surfaces are centered. Attach the clevises
to the horns.
D
D.. Slide the retainers over the
clevises.
STEP 6: Attach the Clevises to the Control Surfaces
Nylon Clevis (2)
Silicone Clevis
Retainer
Nylon Clevis
Silicone Clevis
Retainer
Silicone Clevis
Retainer
Clevis Tool
Antenna Wire
Actual Size
Retainer
Silicone Clevis
Retainer (2)
11
A
A.. Position a nylon
strap on the
antenna wire about
6" away from the
receiver. This is
called “strain relief.”
B
B.. Route the antenna
wire through the
longer slot where
you installed
the switch.
Nylon Strap (1)
Actual Size
