13
A
A.. Attach a clevis with retainer onto the remaining
pushrod wire.
B
B.. Insert the wire into the fuselage so that it passes
through the brass connector on the throttle servo.
STEP 2: Install the Throttle Control Linkage
Place the engine onto the engine
mount. Use the plywood gauge
to set the distance from the
firewall. The engine should be
positioned straight or slightly to
the right (NEVER LEFT).
Cut the fuel tubing
so that each tube
sticks out about 6".
Engine Installation
Part
Part
Four
Four
STEP 1: Install the Engine
C
C.. Attach the clevis to the
throttle arm and slide the
retainer in place.
4 x 20mm Screw (4)
4 x 20mm Screws
Tip! If installing an O.S.
®
40
LA engine, install the back
two screws with plates first.
Next, slide the engine into
position and install the
front screws. This is because
access is restricted due to
the remote needle valve.
4mm Nut (4)
4mm Nuts
Brass Connector
Carburetor arm
4mm Split Washer (4)
4mm Split Washers
Mounting Plates
Distance Gauge
Position the
engine straight
or slightly right.
Actual Size
Nylon Clevis (1)
Cut the pushrod
tube off to
approximately 1/8"
from the firewall.
Silicone Clevis
Retainer (1)
Actual Size
