12
A
A.. Insert the steering pushrod wire through the outer hole in
the nylon steering arm. Slide the wire into the tube so
that it will extend through the brass connector on the
rudder servo.
B
B.. Place a 4mm metal collar over the nose gear strut. Slide
the strut in place capturing the steering arm between the
bottom bracket and engine mount.
C
C.. Tighten the steering arm screw so the end of the steering
arm is positioned about 3/8" (10mm) from the firewall while
the nose gear is straight.
D
D.. From the inside fuselage, tighten the screw to secure the
pushrod to the brass connector.
STEP 1: Install the Steering Hardware
Landing Gear Installation
Part
Part
A
A.. Insert the two main landing
gear wires into the slots on the
bottom of the fuselage.
B
B.. Secure the landing gear using
two metal straps and four
2.5 x 10mm screws.
C
C.. Attach the wheels using the
4mm metal collars with the
3 x 5mm screws.
STEP 2: Install the Main Landing Gear and Wheels
4mm Metal Collar (1)
4mm Metal Collar (6)
3 x 5mm Screw (1)
3 x 5mm Screw (6)
2.5 x 10mm Screw (4)
Metal Strap (2)
3 x 8mm Screw (1)
3 x 8mm Screw
Nylon Steering
Arm
Metal Collar
2.5 x 10mm Screw
3 x 5mm
Screw
3 x 5mm
Screw
Pushrod
Tube
Nose Gear
Strut
3 x 5mm Screw
Pushrod
Use drill bit to
enlarge the
outside hole.
Actual Size
Actual Size
Actual Size
IMPORTANT! Check and
retighten the engine
mount screws.
