Hobart 6824-1, Operation And Maintenance Manual, Page: 64 / 214

b. Control Box Trays
Control box trays may be removed easily and moved to a work bench for service or replacement of
parts.
(1) Tray removal
a. Loosen screw-lock fastener (2, Fig. 6)
b. Slide tray outward and disconnect Amphenol connector (3).
c. Support tray with hands at each side of tray near latches (1).Unlock latches (1) by pressing
down with thumbs, then slide tray out of box.
(2) Tray installation
a. Use both hands to support tray as in removal above.
b. Align rails (4) with tracks (5) and slide tray into box. Latches will lock automatically.
c. Connect Amphenol connector (3).
c. Generator Exciter
Provisions have been made to allow removal of the generator exciter without disturbing or
removing the complete generator.
(1)
Preparation for exciter removal.
a. Remove main frame rear cross member by removing four attaching cap screws (See Fig. 7).
(2) Exciter removal
Refer to TM-360 in Chapter 6 for exciter instructions.
1. Latch
2. Fastener
3. Connector
4. Rail
5. Track
Tray Removal
(Typical)
Figure 6
OM-499
2-1 May 31/94 Revised
Page 10