Hobart 6824-1, Operation And Maintenance Manual, Page: 42 / 214

(7)
Check air cleaner
The air cleaner
(Sect. 1-1, Fig. 3, item 8)
is a “dry” type. Be sure there are no papers, tapes, or
other material covering the air inlet area.
c. Installing Output Cables Units are generally shipped without generator set-to-aircraft cables.
NOTE: Generator sets designed for tractor mounting are equipped with a generator output receptacle
connector. No output cable wiring is required. An output cable assembly with plug connector on
each end is required for tractor-mounted machines (see 1-1; 12, Fig. 3).
(1) Three-phase, AC output cable assembly installation
The AC output terminal panel is located on the left side, below the air cleaner and left of the
engine control panel
(see Fig. 1).
a. Open left rear canopy doors and loosen cable clamp screws at cable horn (see 1-1; 13, Fig.
3).
b. Route cables through cable horn and clamp and upward to terminal board.
NOTE: Conductor size recommended for AC output is 2/0 size. Use No. 12 size for control (E and F
terminals). Large cables (A, B, C, N) should be equipped with terminals having at least a
3/8-inch diameter mounting hole. Mounting hole in small leads (E and F) should be at least
1/4-inch diameter.
c. Each terminal stud is identified by an identification plate. Each cable should be identified by
a band-type marker. Connect cable “A” to terminal “A”, “B” to “B”, etc. Tighten terminal nuts
securely. Connect small plug interlock lead “E” or “F” to terminal “E” or “F”.
d. Tighten clamp screws securely, but avoid damage to cable insulation.
AC Output Terminal Panel
Figure 1
OM-499
1-2 May 31/94 Revised
Page 2