HV100 Series High Performance Current Vector Inverter
95
0: stop counting and output
1: stop counting and continue outputting
2
：
cycle the counting,and stop output
3: cycle counting, and continue to output
When the count value of the counter reaches the value, set by function code 07.32, the corresponding action of the inverter
is performed.
07.31
Starting condition of Counting
0
～
1
1
0: Always start when powered on
1: Start when running, will stop when stopping
The above premise is that there is a counting pulse input
07.32
Setting reset value of the counter
【
07.33
】～
65535
0
07.33
Setting detection value of counter
0
～【
07.32
】
0
This function code defines the reset value and detection value of the counter. When the counting value of the counter
reaches the value, set by function code 07.32, the corresponding multi-function output terminal (counter reset signal output)
outputs an valid signal and clears the counter.
When the count value of the counter reaches the value, set by function code 07.33, an valid signal is output at the
corresponding multi-function output terminal (counter detection signal output). If counting continues and exceeds the value,
set by function code 07.32, the output valid signal will be cancelled when the counter is cleared.
As shown in the following figure, the programmable relay output is set as the reset signal output, and open collector
output Y1 set as counter detection output, 07.32 as 8 and 07.33 as 5. When the detection value is 5, Y1 keeps to output an
valid signal; When the reset value reaches 8, the relay outputs an valid signal of one pulse period and clears the counter. At
the same time, Y1, the relay cancel the output signal.
Figure F7-9 Schematic diagram for counter setting of reset and detection
07.34
Processing of Timing arrival
0
～
3
3
0: stop timing and output
1: stop timing and continue output
2
：
cycle timing, stop output
3: cycle counting, continue to output
When the count value of the counter reaches the value, set by function code 07.36, the corresponding action of the
inverter is performed.
07.35
Timing starting condition
0
～
1
1
0: Always start when powered on
1: Start when running,will stop when stopping
07.36
Setting of the timing time
0
～
65535S
0
07.37
Y1 delay time of disconnect
0.0
～
100.0s
0.0
Relay
